Power Installation and 3.5” Fan Speed Controller Installation...7 Power Installation and PCI Fan Speed Controller Installation...8 Installation Instructions for P4 LGA775RM & Cooler...9 Installation Instructions for Intel® Pentium® 4 mPGA478 Clips...10 Installation Instructions for AMD K8 (939 / 754) Clip...11 Installation Instructions for AMD K7 Clip...12...
Precautions The cooler fan speed levels provided are for reference use only. Please refer to the motherboard BIOS to verify actual fan speed levels. Each connector on the fan control box is foolproof. Read the user’s manual before use. Before use, please remove the bottom protective layer of the cooler. Please make sure the computer is turned off and its power disconnected prior to installation.
Installation Instructions for Fan Control Box & Power Cable Fan Control Box Power Cable connector Connect the other end of the power Connect the other end of the power cable to the 3-pin CPU fan header cable to the 4-pin CPU fan header on the motherboard.
Power Installation and 3.5” Fan Speed Controller Installation Figure 1 Securely hold the 3.5” fan speed controller bracket in place with the screws provided(Figure 1-1). Figure 1-1 Figure 1-2 Figure 2 Connect the cable connector of the 3.5" fan speed controller to the fan control box (Figure 2-1).
Power Installation and PCI Fan Speed Controller Installation Figure 1 Disassemble the turn knob, bolt and fan speed controller from the 3.5” bracket and reassemble these parts onto a PCI bracket in sequence. Figure 1-1 Figure 1-2 Figure 2 Place the PCI bracket with the fan speed controller in the selected PCI slot.
4-pin CPU fan header does not necessarily have to be connected (Figure 3-2). Note: About P4 Clips installation, please refer to “Installation Figure3- 1 Figure3-2 Instructions for Intel ® Pentium - 9 - ® 4 mPGA478 Clips”...
Installation Instructions for Intel ® Pentium ® 4 mPGA478 Clips Figure 1 Please add an adequate layer of heat sink paste on the surface of the CPU(Figure1-1). Figure 1-2 showing the correct installation of the cooler atop the CPU. Figure 1-1...
Installation Instructions for AMD K8 (939 / 754) Clip Figure 1 Please add an adequate layer of heat sink paste on the surface of the CPU. Figure 1-1 Figure 1-2 Figure 2 Figure showing the correct installation of the cooler atop the CPU.
Installation Instructions for AMD K7 Clip Figure 1 Please add an adequate layer of heat sink paste on the surface of the CPU. Remove the bracket of the cooler along the direction of the arrow (Figure 1-2). The bracket should Figure 1-1 Figure 1-2 Figure 1-3...