Figure 8-8 Removing A Drive From The Peripheral Carrier - Silicon Graphics Origin200 Owner's Manual

Chapter 8: Installing and Configuring Peripherals
168
5. Remove the screws that hold the drive to the peripheral carrier and remove the
drive from the carrier, as shown in Figure 8-8.
Figure 8-8 Removing a Drive From the Peripheral Carrier
6. Replace the blanking and access plates on the peripheral carrier. See Figure 8-9.
The front blanking plate ensures proper airflow through the system.
The rear access plate protects the cables in the peripheral carrier from damage
when installing and removing the carrier.
Front