Advertisement
Estimated Time Required
15 to 30 minutes.
Tools Required
A T10 TORX screwdriver.
System Preparation
Complete the following steps to prepare the system for the BaseIO card replacement procedure:
1.
Have the customer shut down the SAP HANA database.
2.
Have the customer shut down the operating system.
3.
Run
rmc> uv3dmp
4.
Power down the system.
5.
Disconnect the chassis from site power.
6.
Provide clearance for the chassis to slide in the rack:
a.
b.
c.
BaseIO Card Replacement Procedure
Removing a BaseIO Card
1.
Grasp the handles and slide the chassis out the front of the rack until the chassis locks in place.
2.
Remove the T10 TORX screws that secure the front top cover to the chassis.
3.
Slide the cover toward the front of the chassis and lift off of the chassis.
Caution:
4.
Disconnect the cables from the BaseIO card.
5.
Remove the Base IO retaining screw from the top of the bulkhead.
6.
Remove the SSD drives from the BaseIO card and note the location of each drive.
7.
Grasp the BaseIO card and pull straight up to remove it from the chassis.
2
to log the hardware status prior to replacing the part:
uv3dmp
Remove the bezel.
Remove the NUMAlink and other cables from the front of the chassis.
Remove the power cables from the rear of the chassis.
Components inside the chassis can be hot. Wait at least five minutes before removing
components from the chassis.
Replacing a BaseIO Card in an SGI® UV™ 300H Server
007-6442-002
Advertisement
