Displaying The Synchronization - HP PROCURVE 6208M-SX Installation And Getting Started Manual

Hewlett-packard switch user manual
Hide thumbs Also See for PROCURVE 6208M-SX:
Table of Contents

Advertisement

Automatically synchronized
at startup or switchover
Startup-config also
automatically updated
with write memory
command
System software
(flash code)
System software
(flash code)
Figure 5.1
Redundant management module file synchronization
Displaying the Synchronization Settings
You can independently synchronize the following types of software between the active and standby modules:
boot code
flash code (system software)
startup-config file
running-config
When you synchronize software between the modules, the active module copies its software to the standby
module.
To display the current file synchronization settings, enter the following command:
HP9300# sync-standby
Sync code image: TRUE
Automatically synchronized
at regular, user-configurable
intervals
Also can be immediately
synchronized using the
CLI or Web management interface
Active
Redundant Management
Startup-config file
Running-config file
Standby
Redundant Management
Startup-config file
Running-config file
Using Redundant Management Modules
Not automatically synchronized
but can be configured to synchronize
at startup or switchover
Also can be immediately synchronized
using the CLI or Web management interface
Module
Boot code
Module
Boot code
5 - 11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 1600m

Table of Contents