HP PROCURVE 6208M-SX Installation And Getting Started Manual page 234

Hewlett-packard switch user manual
Hide thumbs Also See for PROCURVE 6208M-SX:
Table of Contents

Advertisement

USING THE CLI
To enable active IGMP, enter the following command:
HP6208(config)# ip multicast active
HP6208(config)# write memory
HP6208(config)# end
HP6208# reload
Syntax: [no] ip multicast active | passive
To enable passive IGMP, enter the following command:
HP6208(config)# ip multicast passive
HP6208(config)# write memory
HP6208(config)# end
HP6208# reload
USING THE WEB MANAGEMENT INTERFACE
To change the IGMP mode:
1.
Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2.
Select Active or Passive next to IGMP.
3.
Click the Apply button to save the change to the device's running-config file.
4.
Select the Save link at the bottom of the dialog, then select Yes when prompted to save the configuration
change to the startup-config file on the device's flash memory.
Disabling IGMP on Individual Ports
By default, when you enable IP multicast on the HP 6208M-SX, all ports on the switch are configured for IGMP. If
you are using active IGMP, all ports can send IGMP queries and receive IGMP reports. If you are using passive
IGMP, all ports can receive IGMP queries.
You can disable IGMP on individual ports if you want to block all IP multicast traffic on those ports. When you
disable IGMP on an individual port, the switch does not forward any multicast traffic out the port, but other ports
can still send and receive multicast traffic.
To disable IGMP on a port, use the following CLI method.
NOTE: You must reload the software after making this configuration change and saving it to the startup-config
file.
USING THE CLI
HP9300(config)# int e 1/5
HP9300(config-if-1/5)# ip-multicast-disable
Syntax: [no] ip-multicast-disable
The command in this example disables IGMP on port 1/5 but does not affect the state of IGMP on other ports.
USING THE WEB MANAGEMENT INTERFACE
You cannot disable IGMP on a port using the Web management interface.
Modifying the Query Interval
The query interval specifies how often the HP 6208M-SX enabled for active IP Multicast Traffic Reduction sends
Group Membership queries.
NOTE: The query interval applies only to the active mode of IP Multicast Traffic reduction.
To modify the query interval, use the following CLI method.
Configuring Basic Features
9 - 49

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 1600m

Table of Contents