The Status column shows the module status. The redundant management modules can have one of the following
statuses:
•
ACTIVE – The module is currently the active management module.
•
STANDBY – The module is the standby management module.
The statuses above apply only to management modules. The following statuses apply only to host modules:
•
FAILED – This status applies only to host modules, not to management modules. This status indicates that
the host module failed to come up.
•
OK – This status applies only to host modules, not to management modules. This status indicates that the
module came up and is operating normally.
Displaying Switchover Messages
You can determine whether a switchover has occurred by viewing the system log or the traps logged on an SNMP
trap receiver.
USING THE CLI
To view the system log, enter the following command at any level of the CLI:
HP9300> show log
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 8 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
Static Log Buffer:
Dynamic Log Buffer (50 entries):
at 0 days 0 hours 0 minutes 0 seconds, level alert
Using Redundant Management Modules
5 - 9