HP PROCURVE 6208M-SX Installation And Getting Started Manual Page 201

Hewlett-packard switch user manual.
Hide thumbs
Installation and Getting Started Guide
debugging
emergencies
errors
informational
notifications
warnings
The commands in the example above change the log level to notification messages or higher. The software will
not log informational or debugging messages. The changed message level also applies to the SyslogD servers.
Changing the Number of Entries the Local Buffer Can Hold
You also can use the logging buffered command to change the number of entries the local Syslog buffer can
store. For example:
HP9300(config)# logging buffered 100
The default number of messages is 50. The value can be 50 – 100. The change takes effect immediately and
does not require you to reload the software.
NOTE: If you decrease the size of the buffer, the software clears the buffer before placing the change into effect.
If you increase the size of the buffer, the software does not clear existing entries.
Changing the Log Facility
The SyslogD daemon on the SyslogD server uses a facility to determine where to log the messages from the HP
device. The default facility for messages the HP device sends to the SyslogD server is "user". You can change
the facility using the following command.
NOTE: You can specify only one facility. If you configure the HP device to use two SyslogD servers, the device
uses the same facility on both servers.
HP9300(config)# logging facility local0
Syntax: logging facility <facility-name>
The <facility-name> can be one of the following:
kern – kernel messages
user – random user-level messages
mail – mail system
daemon – system daemons
auth – security/authorization messages
syslog – messages generated internally by syslogd
lpr – line printer subsystem
news – netnews subsystem
uucp – uucp subsystem
sys9 – cron/at subsystem
sys10 – reserved for system use
sys11 – reserved for system use
sys12 – reserved for system use
sys13 – reserved for system use
9 - 16

Advertising

   Related Manuals for HP PROCURVE 6208M-SX

Comments to this Manuals

Symbols: 0
Latest comments: