HP PROCURVE 6208M-SX Installation And Getting Started Manual page 26

Hewlett-packard switch user manual
Hide thumbs Also See for PROCURVE 6208M-SX:
Table of Contents

Advertisement

Super Aggregated VLANs
Support for simultaneous Telnet configuration by multiple users
New CLI command for displaying dynamic memory utilization
SNMP V2 view
Enhancement to show default values command
CLI enhancements to the startup-config and running-config files
Page display is configurable for individual CLI management sessions
CLI enhancement to display the idle time for open CLI sessions
New CLI command for displaying TACACS+ or RADIUS information
Enhancement to the show web command
New option for setting the timeout for Telnet sessions
Enhancements to show interface command
ACL configuration supported in the Web management interface
Greeting banners are displayed at the beginning of a Web management session
Increasing the Syslog buffer size does not clear entries
The newline character does not appear in Syslog and SNMP trap messages
New MIB tables for Adaptive Rate Limiting
Support for Secure Shell (SSH) for remote access to the CLI
Support up to 12 trunk groups on 24-port 10/100 modules
Strict ACL TCP mode
Support for per-port ACL assignment within a virtual interface's VLAN
New commands for copying files between a device's flash memory and a TFTP server
Change to the IP address used when you enable the routing switch to use a single IP address on the device
as the source for all Telnet, RADIUS, or TACACS/TACACS+ packets originated by the device
Option to suppress Telnet connection rejection message
Configurable block size for TFTP file transfers
Support and Warranty Information
Refer to Support is as Close as the World Wide Web, which was shipped with your HP switch or routing switch.
Getting Started
1 - 5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 1600m

Table of Contents