Swapping Modules - HP PROCURVE 6208M-SX Installation And Getting Started Manual

5. Enable or disable elements on the Web management interface by clicking on the appropriate radio buttons on
the panel. The following figure identifies the elements you can change.
Menu Type
(Tree View
shown)
Menu Frame
NOTE: The tree view is available when you use the Web management interface with Netscape 4.0 or higher
or Internet Explorer 4.0 or higher browsers. If you use the Web management interface with an older browser,
the Web management interface displays the List view only, and the Web Management Preferences panel
does not include an option to display the tree view.
6. When you have finished, click the Apply button on the panel, then click the Refresh button on your browser to
activate the changes.
7. To save the configuration, click the plus sign next to the Command folder, then click the Save to Flash link.
NOTE: The only changes that become permanent are the settings to the Menu Type and the Front Panel
Frame. Any other elements you enable or disable will go back to their default settings the next time you start
the Web management interface.
13. Swapping Modules (Chassis Devices only)
After you physically insert a module into a Chassis device, you need to enter the location and type of module in
the software, unless you either reboot the device or are replacing one module with another of the same type.
• Slots on the HP 9304M are numbered 1 – 4, from top to bottom.
• Slots on the HP 9308M are numbered 1 – 8, from left to right.
See "Slot and Port Numbers" on page 8-8 for more information about slot and port numbering.
Installation
Front Panel
Front Panel
Frame
Page Menu
Bottom Frame
2 - 25