HP PROCURVE 6208M-SX Installation And Getting Started Manual Page 53

Hewlett-packard switch user manual.
Hide thumbs
Installation and Getting Started Guide
NOTE: If the slot has never contained a module or you are swapping in exactly the same type of module, you do
not need to use the module command. The slot requires configuration only if it has already been configured for
another type of module.
USING THE CLI
To add a module to a Chassis device:
HP9300(config)# module 3 24-port-copper-module
Syntax: module <slot-num> <module-type>
The <slot-num> parameter indicates the Chassis device slot number.
The <module-type> parameter can be one of the following. You can, of course, take advantage of the CLI's
support for abbreviated command and parameter names.
NOTE: Some module strings apply to more than one module. This is because the slot configuration does not dif­
fer based on the physical layer. For example, a slot does not distinguish between an 8-port LX Fiber module and
8-port SX Fiber module. However, the software does indicate the physical layer type when you display module
information. For example, the output of the show module command indicates the physical layer types of each
module.
Module Type
Redundant Management
modules (MII)
Management modules (MI)
2 - 26
Table 2.3: Module Options
Part Number and Description
J4845A
HP ProCurve 9300 GigLX
Redundant Management Module
(8-port)
J4846A
HP ProCurve 9300 GigSX
Redundant Management Module
(8-port)
J4847A
J4847A HP ProCurve 9300
Redundant Management Module
(0-port)
J4141A
ProCurve 9300 10/100
Management Module (16-port)
J4144A
HP ProCurve 9300 Gigabit SX
Management Module (8-port)
J4146A
HP ProCurve 9300 Gigabit 4LX/
4SX Management Module (8­
port)
Module String
8-port-gig-management-module
8-port-gig-management-module
0-port-management-module
16-port-copper-management­
module
8-port-gig-management-module
8-port-gig-management-module

Advertising

   Related Manuals for HP PROCURVE 6208M-SX

Comments to this Manuals

Symbols: 0
Latest comments: