Installation and Getting Started Guide
NOTE: The text shown in italics in the CLI example below shows messages echoed to the screen in answer to
the CLI commands entered.
Enter these commands on Router1:
HP9304(config)# trunk switch e 1/1 to 1/2
Trunk 2 is created for next power cycle.
Please save configuration to flash and reboot.
HP9304(config)# write memory
Write startup-config in progress.
.Write startup-config done.
HP9304(config)# exit
HP9304# reload
Enter these commands on Router2:
HP9304(config)# trunk server e 4/1 to 4/2
Trunk 0 is created for next power cycle.
Please save configuration to flash and reboot.
HP9304(config)# write memory
Write startup-config in progress.
.Write startup-config done.
HP9304(config)# exit
HP9304# reload
Syntax: trunk server | switch ethernet <portnum> to <portnum>
You then configure the trunk group on the HP ProCurve Switch 4000M. For more information, see the
documentation for the HP ProCurve Switch 4000M.
USING THE NETWORK MANAGEMENT INTERFACE
To configure ports 5 – 8 as a trunk group between two switches, two routing switches, or a switch or routing switch
and a server:
1.
Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2.
Click on the plus sign next to Configure in the tree view to display the configuration options.
•
If the device does not have any trunk groups configured, the Trunk configuration panel is displayed, as
shown in the following example.
•
If a trunk group is already configured and you are adding a new one, click on the Add Trunk Group link to
display the Trunk configuration panel, as shown in the following example.
•
If you are modifying an existing trunk group, click on the Modify button to the right of the row describing
the trunk group to display the Trunk configuration panel, as shown in the following example.
9 - 40