Ac Power Connector - HP PROCURVE 6208M-SX Installation And Getting Started Manual

Hewlett-packard switch user manual
Hide thumbs Also See for PROCURVE 6208M-SX:
Table of Contents

Advertisement

Installation and Getting Started Guide
NOTE: The rear panel of the HP 9308M and HP 9304M Chassis devices provide no network or power
connections and therefore are not shown.
Slot and Port Numbers
The port numbers on all Fixed-port devices and Chassis devices are labeled on the hardware. However, the
method you use to enter or select a port number differs depending on whether you are managing a Fixed-port
device or a Chassis device.
Fixed-Port Devices
To specify a port number in the software, enter or select the number associated with the port on the device's front
panel. For example, to assign a name to port 8 on a Fixed-port device, enter the following CLI commands:
HP6208(config)# interface e 8
HP6208(config-if-8)# port-name pdtmarketing
Syntax: interface ethernet <portnum>
Syntax: port-name <string>
Chassis Devices
The port numbers on the modules in Chassis devices are labeled, but the slot numbers are not labeled.
Slots on the HP 9304M are numbered 1 – 4, from top to bottom.
Slots on the HP 9308M are numbered 1 – 8, from left to right.
You can place the management module in any slot. The slot numbers are absolute and do not change based on
the position of the management module.
To specify a port on a Chassis device, enter the slot number, a forward slash ( / ), and the number associated with
the port on the device's front panel. For example, to assign a name to port 8 on the module installed in chassis
slot 2, enter the following commands:
HP9300(config)# interface e 2/8
HP9300(config-if-2/8)# port-name pdtmarketing
Syntax: interface ethernet <portnum>
Syntax: port-name <string>
NOTE: The Fixed-port devices do not contain separate slots and thus do not use slot numbers.

AC Power Connector

The AC power connectors are located at the rear of the Fixed-port devices. Because a redundant supply is
installed, the rear panel contains two AC connectors.
On Chassis devices, the power supplies are accessible from the front of the chassis, and the power supply
connector is embedded within the power supply.
Buffering
Fixed-port devices provide a pool of 2 Megabytes (MB) of buffering memory for their ports. Buffering memory for
each chassis module is also 2 MB.
Fans
The HP 6308M-SX routing switch and HP 6208M-SX switch come standard with two fans to provide additional
cooling for the internal components of the device.
8 - 8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 1600m

Table of Contents