HP PROCURVE 6208M-SX Installation And Getting Started Manual page 73

Hewlett-packard switch user manual
Hide thumbs Also See for PROCURVE 6208M-SX:
Table of Contents

Advertisement

Installation and Getting Started Guide
2.
Select the Community String link to display the SNMP Community String panel, as shown in the following
example. This example shows the table listed for a system that is configured only with the default read-only
community string "public".
3.
Select the Add Community String link to display a panel such as the following.
4.
Select the community string type:
Select Get for a read-only string.
Select Set for a read-write string.
5.
Enter the community string in the Community String field.
6.
Select the Encrypt checkbox to remove the checkmark if you want to disable encryption of the string display.
Encryption prevents other users from seeing the string in the CLI or Web management interface. If you
disable encryption, other users can view the community string. Encryption is enabled by default.
To re-enable encryption, select the checkbox to place a checkmark in the box.
7.
Click the Add button to save the change to the device's running-config file.
8. Repeat steps 5 – 7 for each string you want to add. You can add as many strings as you need. The limit
depends only on the available system memory.
9.
Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
Configuring TACACS/TACACS+ Security
You can use the security protocol Terminal Access Controller Access Control System (TACACS) or TACACS+ to
authenticate the following kinds of access to the HP device
Telnet access
SSH access
3 - 16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 1600m

Table of Contents