HP PROCURVE 6208M-SX Installation And Getting Started Manual page 244

Hewlett-packard switch user manual
Hide thumbs Also See for PROCURVE 6208M-SX:
Table of Contents

Advertisement

IP routes
IP route filters
IP sub-nets per port and per device
Static routes
IGMP
DVMRP routes
IPX/SAP entries
IPX/RIP entries
IPX/SAP filters
IPX/RIP filters
IPX forwarding filters
AppleTalk routes
AppleTalk zones
The tables you can configure and the defaults and valid ranges for each table differ depending on the HP device
you are configuring.
NOTE: If you increase the number of sub-net addresses you can configure on each port to a higher amount, you
might also need to increase the total number of sub-nets that you can configure on the device.
To display and configure the adjustable tables on a device, use one of the following methods.
NOTE: Changing the table size for a parameter reconfigures the device's memory. Whenever you reconfigure
the memory, you must save the change to the startup-config file, then reload the software to place the change into
effect.
USING THE CLI
To display the configurable tables and their defaults and maximum values, enter the following command at any
level of the CLI:
HP9300# show default values
sys log buffers:50
ip arp age:10 min
ip addr per intf:24
when multicast enabled :
igmp group memb.:140 sec
when ospf enabled :
ospf dead:40 sec
ospf transit delay:1 sec
when bgp enabled :
bgp local pref.:100
bgp metric:10
bgp ext. distance:20
System Parameters
ip-arp
ip-static-arp
mac age time:300 sec
bootp relay max hops:4
igmp query:60 sec
ospf hello:10 sec
bgp keep alive:60 sec
bgp local as:1
bgp int. distance:200
Default
Maximum
8000
64000
1024
2048
telnet sessions:5
ip ttl:64 hops
ospf retrans:5 sec
bgp hold:180 sec
bgp cluster id:0
bgp local distance:200
Current
8000
1024
Configuring Basic Features
9 - 59

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 1600m

Table of Contents