HP PROCURVE 6208M-SX Installation And Getting Started Manual page 247

Hewlett-packard switch user manual
Hide thumbs Also See for PROCURVE 6208M-SX:
Table of Contents

Advertisement

Installation and Getting Started Guide
NOTE: To monitor just the in traffic, enter "in" instead of "both" in the above command. To monitor only the out
traffic, enter "out" instead of "both" in the above command.
USING THE WEB MANAGEMENT INTERFACE
EXAMPLE:
Suppose you want to diagnose the in and out on traffic on port 3 on a module in slot 4 of an HP 9304M or HP
9308M using port 1 in slot 4. To do so:
1.
Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2.
Select the Advance link to display the advanced system configuration panel.
3.
Select the slot (if applicable) and port from the corresponding pulldown menus next to Mirror Slot. In this
example, select slot 4 and port 1.
4.
Click Apply to save the changes to the device's running-config file.
5.
Click on the plus sign next to Configure in the tree view to display the configuration options.
6.
Select the Port link to display the Port table.
7. Click the Modify button next to the port you want to monitor. In this example, select port 3 on the module in
slot 4 (4/3).
8.
Select the traffic direction you want to monitor. For this example, select In & Out.
9.
Click Apply to save the changes to the device's running-config file.
10. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
Displaying the Current Mirror and Monitor Port Configuration
You can display the current port mirroring and monitoring configuration using the following CLI method.
USING THE CLI
To display the current mirroring and monitoring configuration, enter the following command at any level of the CLI:
HP9300(config)# show monitor
Mirror Interface:
Monitored Interfaces:
Both
--------------------------------------------------­
ethernet 4/3
Syntax: show monitor
This example shows the monitoring and mirroring configuration set up by the commands in the example in the
previous section. Port 4/1 is the mirror interface, to which the software copies ("mirrors") the traffic on port 4/3. In
this case, both directions of traffic on the monitored port are mirrored to port 4/1.
If only the incoming traffic is mirrored, the monitored interface is listed under Input. If only the outbound traffic is
mirrored, the monitored interface is listed under Output.
USING THE WEB MANAGEMENT INTERFACE
You cannot display this information using the Web management interface.
9 - 62
ethernet 4/1
Input
Output

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 1600m

Table of Contents