HP PROCURVE 6208M-SX Installation And Getting Started Manual Page 138

Hewlett-packard switch user manual.
Hide thumbs
USING THE CLI
To change the block size for TFTP file transfers, enter a command such as the following at the global CONFIG
level of the CLI:
HP9300(config)# flash 2047
set flash copy block size to 2048
Syntax: [no] flash <num>
The software rounds up the <num> value you enter to the next valid power of two, and displays the resulting
value. In this example, the software rounds the value up to 2048.
NOTE: If the value you enter is one of the valid powers of two for this parameter, the software still rounds the
value up to the next valid power of two. Thus, if you enter 2048, the software rounds the value up to 4096.
USING THE WEB MANAGEMENT INTERFACE
You cannot configure this option using the Web management interface.
Updating Boot Code
Under certain conditions, HP support personnel may request you to update the boot code on a routing switch
management module. Because the boot code is essential for the management module to operate, and because
no backup copy is stored on the module, extreme caution is necessary when updating this code. Use the
following steps to verify TFTP operation and to update the boot code.
1. Use the show flash command to verify the current boot code version. The last line in this example shows
the verification output for boot code version 07.01.01:
HP9308> enable
HP9308# show flash
Active management module:
Code Flash Type: AMD 29F032B, Size: 64 * 65536 = 4194304, Unit: 2
Boot Flash Type: AMD 29F040, Size: 8 * 65536 = 524288
Compressed Primary Code size = 2579100, Version 07.1.10T53
Compressed Secondary Code size = 2053824, Version 06.6.16T53
Maximum Code Image Size Supported: 2817536 (0x002afe00)
Boot Image Version 07.01.01
2.
Verify that your TFTP server interoperates properly with the routing switch. To do so, copy the software image
stored in secondary flash to a TFTP server, delete the image from secondary flash, and then copy the image
you saved onto the TFTP server back into secondary flash. For example, if the IP address of the TFTP server
is 192.168.1.1 and the file name you will use to store the image is H2R06616.bin:
a.
Copy the software image stored in secondary flash to the TFTP server.
HP9308# copy flash tftp 192.168.1.1 H2R06616.bin sec
HP9308#Flash to TFTP Done.
b.
On the routing switch, delete the software image stored in secondary flash and verify that secondary
flash is empty. (If secondary flash is empty, you will see "size = 0" in the "Compressed Secondary Code"
line of the show flash command output.) For example:
HP9308# erase flash secondary
Flash Erase HP9308#-------------------------------Erase flash Done.
HP9308# show flash
Active management module:
Code Flash Type: AMD 29F032B, Size: 64 * 65536 = 4194304, Unit: 2
Boot Flash Type: AMD 29F040, Size: 8 * 65536 = 524288
Compressed Primary Code size = 2579100, Version 07.1.10T53
Updating Software Images and Configuration Files
6 - 3

Advertising

   Related Manuals for HP PROCURVE 6208M-SX

Comments to this Manuals

Symbols: 0
Latest comments: