HP PROCURVE 6208M-SX Installation And Getting Started Manual Page 214

Hewlett-packard switch user manual.
Hide thumbs
Modifying Port Priority (QoS)
You can give preference to the inbound traffic on specific ports by changing the Quality of Service (QoS) level on
those ports. For information and procedures, see the "Quality of Service (QoS)" chapter in the Advanced
Configuration and Management Guide.
Configuring Basic Layer 2 Parameters
The procedures in this section describe how to configure the following Layer 2 parameters. Note that some of
these parameters apply only to HP switches, not HP routing switches.
Layer 2 switching of unsupported router protocols (routing switches only) – see "Enabling or Disabling Layer
2 Switching (routing switches only)" on page 9-29
Aging time for learned MAC address entries – see "Changing the MAC Age Time" on page 9-30
Static, non-aging MAC address entries – see "Configuring Static MAC Entries" on page 9-31
Trunk groups – see "Configuring Trunk Groups" on page 9-34
Port-based VLANs – see "Enabling Port-Based VLANs" on page 9-32
Layer 2 IP Multicast Traffic Reduction feature (switches only) – see "Configuring IP Multicast Traffic
Reduction (HP 6208M-SX only)" on page 9-47
NOTE: This section does not describe the IP Multicast features on HP routing switches. For information
about these features, see the "Configuring IP Multicast Protocols" chapter in the Advanced Configuration and
Management Guide.
MAC address filters – see "Defining MAC Address Filters" on page 9-51
Broadcast and Multicast Filters – see "Defining Broadcast and Multicast Filters" on page 9-55
Port locks – see "Locking a Port To Restrict Addresses" on page 9-57
Enabling or Disabling Layer 2 Switching (routing switches only)
By default, HP routing switches support Layer 2 switching. These devices switch the routing protocols that are not
supported on the devices. If IPX routing is not enabled, then IPX traffic also is switched. By default IPX routing is
disabled. If you want to disable Layer 2 switching, you can do so globally or on individual ports.
NOTE: Make sure you really want to disable all Layer 2 switching operations before you use this option. Consult
your reseller or Hewlett-Packard for information.
USING THE CLI
To globally disable Layer 2 switching on a routing switch, enter commands such as the following:
HP9300(config)# route-only
HP9300(config)# exit
HP9300# write memory
HP9300# reload
To re-enable Layer 2 switching on a routing switch, enter the following:
HP9300(config)# no route-only
HP9300(config)# exit
HP9300# write memory
HP9300# reload
Syntax: [no] route-only
Configuring Basic Features
9 - 29

Advertising

   Related Manuals for HP PROCURVE 6208M-SX

Comments to this Manuals

Symbols: 0
Latest comments: