HP PROCURVE 6208M-SX Installation And Getting Started Manual page 119

Hewlett-packard switch user manual
Hide thumbs Also See for PROCURVE 6208M-SX:
Table of Contents

Advertisement

Installation and Getting Started Guide
Configuring the Chassis to Receive the Module
When you plan to insert a module into a chassis slot, you first must configure the slot to receive the module unless
the slot already contains the same type of module.
USING THE CLI
To prepare slot 1 to receive an 8-port Gigabit redundant management module, enter the following commands at
the global CONFIG level:
HP9300(config)# module 1 8-port-gig-management-module
HP9300(config)# write memory
Syntax: module <slot-num> <module-type>
In the current software release, the <module-type> for a Redundant Management module can be one of the
following:
0-port-management-module – J4847A
8-port-gig-management-module – J4845A or J4846A
See the "Swapping Modules (Chassis Devices only)" on page 2-25 for a list of other module types.
USING THE WEB MANAGEMENT INTERFACE
1.
Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2.
Click on the Module link to display the Module panel, as shown in the following example.
5 - 4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 1600m

Table of Contents