Integrating Using The Ini File - AudioCodes Mediant 1000 User Manual
Sip media gateways
Hide thumbs
Also See for Mediant 1000:
- User manual (1195 pages) ,
- Hardware installation manual (84 pages) ,
- Installation manual (76 pages)
Table of Contents
Advertisement
10.10.3.2
Integrating using the ini File
To integrate the Mediant 1000 into a VLAN and multiple IPs
network using the ini file, take these 3 steps:
1.
Prepare an ini file with parameters shown in
•
If the BootP/TFTP utility and the OAM interface are located in the same network,
the Native VLAN ID (VlanNativeVlanId) must be equal to the OAM VLAN ID
(VlanOamVlanId), which in turn must be equal to the PVID of the switch port the
gateway is connected to. Therefore, set the PVID of the switch port to 4 (in this
example).
•
Configure the OAM parameters (LocalOAMPAddress, LocalOAMSubnetMask
and LocalOAMDefaultGW) only if the OAM networking parameters are different
from the networking parameters used in the Single IP Network mode.
•
The IP Routing table is required to define static routing rules for the OAM and
Control networks since a default gateway isn't supported for these networks.
Figure 10-5: Example of VLAN and Multiple IPs ini File Parameters
; VLAN Configuration
VlanMode=1
VlanOamVlanId=4
VlanNativeVlanId=4
VlanControlVlanId=5
VlanMediaVlanID=6
; Multiple IPs Configuration
EnableMultipleIPs=1
LocalMediaIPAddress=10.33.174.50
LocalMediaSubnetMask=255.255.0.0
LocalMediaDefaultGW=10.33.0.1
LocalControlIPAddress=10.32.174.50
LocalControlSubnetMask=255.255.0.0
LocalControlDefaultGW=0.0.0.0
LocalOAMPAddress=10.31.174.50
LocalOAMSubnetMask=255.255.0.0
LocalOAMDefaultGW=0.0.0.0
; IP Routing table parameters
RoutingTableDestinationsColumn = 130.33.4.6, 83.4.87.6
RoutingTableDestinationMasksColumn = 255.255.255.255 , 255.255.255.0
RoutingTableGatewaysColumn = 10.32.0.1 , 10.31.0.1
RoutingTableInterfacesColumn = 1 , 0
RoutingTableHopsCountColumn = 20,20
2.
Use the BootP/TFTP utility (Section
firmware version and the ini file you prepared in the previous step to the Mediant 1000
(VLANs and multiple IPs support is available only when the firmware is burned to
flash).
3.
Reset the Mediant 1000 after disabling it on the BootP/TFTP utility.
SIP User's Manual
Figure 10-5
(refer to the following notes):
D.6
on page 414) to load and burn (-fb option) the
314
Mediant 1000
Document #: LTRT-83301
Advertisement
Table of Contents
