Figure 5-15: Charge Codes Table Screen; Table 5-14: Metering Tones Parameters - AudioCodes MP-124 User Manual

SIP User's Manual
Parameter
Generate Metering Tones
[PayPhoneMeteringMode]
Metering Tone Type
[MeteringType]
Charge Codes Table
5.5.2.3.1 Charge Codes Table
Version 5.2
http://ArtTel.ru

Table 5-14: Metering Tones Parameters

Determines the method used to configure the metering tones that are
generated to the Tel side (FXS gateways only).
[0] Disable = Metering tones aren't generated (default).
[1] Internal Table = Metering tones are generated according to the
internal table configured by the parameter ChargeCode.
Note: If you select 'Internal Table', you must configure the 'Charge
Codes Table' (refer to 'Charge Codes Table' on page 115).
Defines the metering tone (12 kHz or 16 kHz) that is generated by FXS
gateways.
[0] 12 kHz = 12 kHz metering tone (default).
[1] 16 kHz = 16 kHz metering tone.
Note: Suitable (12 kHz or 16 KHz) coeff must be used for FXS gateways.
For detailed information on configuring the Charge Codes Table, refer to
'Charge Codes Table' on page 115.
The Charge Codes table is used to configure the metering tones (and their time interval)
that the FXS gateways generate to the Tel side. To associate a charge code to an outgoing
Tel-to-IP call, use the 'Tel to IP Routing' table.
You can also configure the Charge Codes table using the ini file parameter ChargeCode
(refer to 'Analog Telephony Parameters' on page 294).
To configure the Charge Codes table, take these 6 steps:
Access the 'Metering Tones' screen (Protocol Management menu > Advanced
1.
Parameters submenu > Metering Tones option). Refer to 'Metering Tones' on page
114 to view the screen).
Open the 'Charge Codes Table' screen by clicking the arrow sign (-->) to the right of
2.
the Charge Codes Table label.

Figure 5-15: Charge Codes Table Screen

Description
115
5. Web-based Management
September 2007