Configuring Web And Telnet Access List - AudioCodes Mediant 800B User Manual

authenticate the password with the username. Therefore, this feature implements a two-
factor authentication - what the user has (i.e., the physical card) and what the user knows
(i.e., the login password).
This feature is enabled using the EnableMgmtTwoFactorAuthentication parameter.
Note: For specific integration requirements for implementing a third-party smart card
for Web login authentication, contact your AudioCodes representative.

To log in to the Web interface using CAC:
1. Insert the Common Access Card into the card reader.
2. Access the device using the following URL: https://<host name or IP address>; the
device prompts for a username and password.
3. Enter the password only. As some browsers require that the username be provided,
it's recommended to enter the username with an arbitrary value.
6.7

Configuring Web and Telnet Access List

The Web & Telnet Access List page is used to define IP addresses (up to ten) that are
permitted to access the device's Web, Telnet, and SSH interfaces. Access from an
undefined IP address is denied. If no IP addresses are defined, this security feature is
inactive and the device can be accessed from any IP address. The Web and Telnet Access
List can also be defined using the ini file parameter WebAccessList_x (see ''Web
Parameters'' on page 909).

To add authorized IP addresses for Web, Telnet, and SSH interfaces access:
1. Open the Web & Telnet Access List page (Configuration tab > System menu >
Management > Web & Telnet Access List).
Figure 6-24: Web & Telnet Access List Page - Add New Entry
User's Manual
Mediant 800B Gateway and E- SBC
76 Document #: LTRT-10296