Number Manipulation And Routing Parameters; Routing Parameters; Table 6-49: Routing Parameters - AudioCodes Mediant 2000 User Manual

Parameter
6.15

Number Manipulation and Routing Parameters

This subsection describes the device's number manipulation and routing parameters.

6.15.1 Routing Parameters

The routing parameters are described in the table below.
Parameter
Web: Trunk Group Table
EMS: SIP Endpoints > Phones
[TrunkGroup]
SIP User's Manual
Signal=16
Where 16 is the DTMF code for hook flash
Notes:

The RFC 2833 [4] option is currently not supported.

The device can interwork DTMF HookFlashCode to SIP
INFO messages with Hook Flash indication.

Table 6-49: Routing Parameters

This ini file table parameter is used to define and activate the
device's Trunks, define telephone numbers for them, and assign
them to Trunk Group IDs. The format of this parameter is shown
below:
[TrunkGroup]
FORMAT TrunkGroup_
TrunkGroup_FirstTrunkId, TrunkGroup_FirstBChannel,
TrunkGroup_LastBChannel, TrunkGroup_FirstPhoneNumber,
TrunkGroup_ProfileId, TrunkGroup_LastTrunkId,
TrunkGroup_Module
[\TrunkGroup]
For example:
TrunkGroup 0 = 1, 0, 0, 1, 31 ,401, 0;
Trunk 1, channels 1-31, i.e., E1 span)
TrunkGroup 1 = 2, 1, 1, 1, 24, 301;
Trunk 2, channels 1-24, i.e., T1 span)
TrunkGroup 2 = 3, 0, 7, 1, *, 1000;
Trunks 1-8, all channels, i.e., 8 E1 spans)
Notes:

The first entry in this table starts at index 0.

Trunk ID 1 is depicted as 0 in the table.

The parameter TrunkGroup_Module is not applicable.

For configuring this table in the Web interface, refer to
"Configuring the Trunk Group Table" on page

For a description of ini file table parameters, refer to ''Format
of ini File Table Parameters''
348
Description
Description
Index = TrunkGroup_TrunkGroupNum,
;
(Trunk Group ID 1,
(Trunk Group ID 2,
(Trunk Group ID 3,
on page 199
Document #: LTRT-68809
Mediant 2000
155.
.