Call Hold Parameters; Call Transfer Parameters; Table 6-36: Call Hold Parameters; Table 6-37: Call Transfer Parameters - AudioCodes Mediant 2000 User Manual

6.8.4

Call Hold Parameters

The call hold parameters are described in the table below.
Parameter
Web/EMS: Enable Hold
[EnableHold]
Web/EMS: Hold Format
[HoldFormat]
Web/EMS:Held Timeout
[HeldTimeout]
6.8.5

Call Transfer Parameters

The call transfer parameters are described in the table below.
Parameter
Web/EMS: Enable Transfer
[EnableTransfer]
SIP User's Manual

Table 6-36: Call Hold Parameters

Enables interworking of the Hold/Retrieve supplementary service from
PRI to SIP.

[0] Disable.

[1] Enable (default).
Note: To support interworking of the Hold/Retrieve supplementary service
from SIP to ISDN (for QSIG and EuroISDN), set the parameter
EnableHold2ISDN to 1.
Determines the format of the call hold request.

[0] 0.0.0.0 = The connection IP address in the SDP is 0.0.0.0 (default).

[1] Send Only = The SDP contains the attribute 'a=sendonly'.
Note: This parameter is applicable only to QSIG and Euro ISDN
protocols.
Determines the time interval that the device can allow a call to remain on
hold. If a Resume (un-hold Re-INVITE) message is received before the
timer expires, the call is renewed. If this timer expires, the call is released.

[-1] = The call is placed on hold indefinitely until the initiator of on hold
retrieves the call again(default).

[0 - 2400] =Time to wait in seconds, after which the call is released.

Table 6-37: Call Transfer Parameters

Determines whether call transfer is enabled.

[0] Disable = Disable the call transfer service.

[1] Enable = The device responds to a REFER message
with the Referred-To header to initiate a call transfer
(default).
Notes:

To use call transfer, the devices at both ends must support
this option.

To use call transfer, set the parameter EnableHold to 1.
300
Description
Description
Document #: LTRT-68809
Mediant 2000