Figure 3-66: Account Table; Table 3-21: Account Table Parameters Description - AudioCodes Mediant 2000 User Manual


To configure Accounts:
1. Open the 'Account Table' page (Configuration tab > Protocol Configuration menu >
Proxies/IpGroups/Registration submenu > Account Table
2. To add an Account, in the 'Add' field, enter the desired table row index, and then click
Add . A new row appears.
3. Configure the Account parameters according to the table below.
4. Click the Apply
5. To save the changes, refer to ''
Note:
Parameter
Served Trunk Group
[Account_ServedTrunkGroup]
Served IP Group
[Account_ServedIPGroup]
Serving IP Group
[Account_ServingIPGroup]
SIP User's Manual
Figure 3-66: Account Table Page
button to save your changes.
Saving Configuration''
For a description of the Web interface's table command buttons (e.g.,
Duplicate and Delete), refer to ''Working with Tables''

Table 3-21: Account Table Parameters Description

The Trunk Group ID for which the device performs registration
and/or authentication to a destination IP Group (i.e., Serving IP
Group).
For Tel-to-IP calls, the Served Trunk Group is the source Trunk
Group from where the call initiated. For IP-to-Tel calls, the Served
Trunk Group is the 'Trunk Group ID' defined in the 'IP to Trunk
Group Routing' table (refer to ''Configuring the IP to Trunk Group
Routing'' on page
"Configuring the Trunk Group Table" on page
Note: For the IP2IP application, this parameter must be set to -1
(i.e., no trunk).
The Source IP Group (e.g., IP-PBX) for which registration and/or
authentication is performed.
Note: This field is applicable only when the IP2IP application is
enabled.
The destination IP Group ID (defined in ''
Groups'' on page
enabled) are sent or Authentication is performed. The actual
destination to where the REGISTER requests are sent is the IP
address defined for the Proxy Set ID (refer to ''Configuring the
Proxy Sets Table''
This occurs only in the following conditions:

The parameter 'Registration Mode' is set to 'Per Account' in the
'Trunk Group Settings' table (refer to ''Configuring the Trunk
Group Settings''

The parameter 'Register' in this table is set to 1.
on page
Description
145 ). For defining Trunk
107 ) to where the REGISTER requests (if
on page 103 ) associated with this IP Group.
on page 157 ).
112
Mediant 2000
page item).
173 .
on page 34 .
Groups, refer to
155 .
Configuring the IP
Document #: LTRT-68809