Figure 3-86: Account Table Page; Table 3-23: Account Table Parameters Description - AudioCodes Mediant 600 User Manual

3.3.2.9.3 Configuring Account Table
The 'Account Table' page allows you to define up to 32 Accounts per Trunk Group (Served
Trunk Group) or source IP Group (Served IP Group) for registration and/or digest
authentication (user name and password) to a destination IP address (Serving IP Group).
The Account table can be used, for example, to register to an Internet Telephony Service
Provider (ITSP) on behalf of an IP-PBX to which the device is connected. The registrations
are sent to the Proxy Set ID (see ''Configuring Proxy Sets Table'' on page 120) associated
with these Serving IP Groups.
A Trunk Group or source IP Group can register to more than one Serving IP Group (e.g.,
ITSP's). This can be achieved by configuring multiple entries in the Account table with the
same Served Trunk Group or Served IP Group, but with different Serving IP Groups, user
name/password, host name, and contact user values.
When using the Account table to register a Trunk Group (to a Proxy server), if all trunks
pertaining to the Trunk Group are down, the device un-registers the trunks. If any trunk
belonging to the Trunk Group is returned to service, the device registers them again. This
ensures, for example, that the Proxy does not send INVITEs to trunks that are out of
service.
Notes:

To configure Accounts:
1. Open the 'Account Table' page (Configuration tab > VoIP menu > SIP Definitions
submenu > Account Table).
2. To add an Account, in the 'Add' field, enter the desired table row index, and then click
Add. A new row appears.
3. Configure the Account parameters according to the table below.
4. Click the Apply button to save your changes.
5. To save the changes, see ''Saving Configuration'' on page 197.
Note:
Parameter
Served Trunk Group
[Account_ServedTrunkGroup]
SIP User's Manual
•
For viewing Account registration status, see ''Viewing Registration
Status'' on page 216.
•
You can also configure the Account table using the ini file table
parameter Account (see SIP Configuration Parameters).

Figure 3-86: Account Table Page

For a description of the Web interface's table command buttons (e.g.,
Duplicate and Delete), see ''Working with Tables'' on page 38.

Table 3-23: Account Table Parameters Description

The Trunk Group ID for which you want to register and/or
authenticate to a destination IP Group (i.e., Serving IP Group).
For Tel-to-IP calls, the Served Trunk Group is the source Trunk
Description
128
Mediant 600 & Mediant 1000
Document #: LTRT-83308