Sip Definitions; Configuring Sip Parameters; Configuring Account Table - AudioCodes MediaPack Series MP-11x User Manual

User's Manual
17

SIP Definitions

This section describes configuration of SIP parameters.
17.1

Configuring SIP Parameters

Many of the stand-alone SIP parameters associated with various features can be
configured in the following pages:

SIP General Parameters page: Provides SIP parameters for configuring general SIP
features. To access this page, use the following path: Configuration tab > VoIP menu
> SIP Definitions > General Parameters.

SIP Advanced Parameters page: Provides SIP parameters for configuring advanced
SIP features. To access this page, use the following path: Configuration tab > VoIP
menu > SIP Definitions > Advanced Parameters.
For a description of these parameters, refer to the section corresponding to the feature or
see 'Configuration Parameters Reference' on page 461.
17.2

Configuring Account Table

The Account Table page allows you to define up to 10 Accounts per Hunt Group (Served
Hunt Group). Accounts are used for registration and/or digest authentication using a
username and password to a destination IP address. The Account table can be used, for
example, to register to an ITSP on behalf of an IP-PBX that is connected to the device. The
registrations are sent to the Proxy Set ID (see 'Configuring Proxy Sets Table' on page 176)
associated with the IP Group.
A Hunt Group can register to more than one IP Group (e.g., multiple ITSPs). This can be
achieved by configuring multiple entries in the Account table with the same Served Hunt
Group, but with different Serving IP Groups, user name/password, host name, and contact
user values.
When using the Account table to register a Hunt Group (to a proxy server), if all trunks
pertaining to the Hunt Group are down, the device un-registers the trunks. If any trunk
belonging to the Hunt Group is returned to service, the device registers them again. This
ensures, for example, that the Proxy does not send INVITEs to trunks that are out of
service.
Notes:

To configure Accounts:
1. Open the Account Table page (Configuration tab > VoIP menu > SIP Definitions
submenu > Account Table).
2. In the 'Add' field, enter the desired table row index, and then click Add. A new row
appears.
Version 6.6
•
For viewing Account registration status, see Viewing Endpoint
Registration Status on page 357.
•
The Account table can also be configured using the table ini file
parameter, Account.
181
17. SIP Definitions
MP-11x & MP-124