Sip Definitions; Configuring Sip Parameters; Configuring Account Table - AudioCodes MP-11x User Manual

User's Manual
18

SIP Definitions

This section describes configuration of SIP parameters.
18.1

Configuring SIP Parameters

Many of the stand-alone SIP parameters associated with various features can be
configured in the following pages:

SIP General Parameters page: Provides SIP parameters for configuring general SIP
features. To access this page, use the following path: Configuration tab > VoIP menu
> SIP Definitions > General Parameters.

SIP Advanced Parameters page: Provides SIP parameters for configuring advanced
SIP features. To access this page, use the following path: Configuration tab > VoIP
menu > SIP Definitions > Advanced Parameters.
For a description of these parameters, refer to the section corresponding to the feature or
see 'Configuration Parameters Reference' on page 475.
18.2

Configuring Account Table

The Account Table page lets you define up to 32 Accounts per ("served") Hunt Group.
Accounts are used to register and/or digest authenticate a Hunt Group, using a username
and password, to a destination ("serving") IP Group. For example, the device can use the
Account table to register a PBX, which is connected to the device, to an ITSP. The device
sends the registration requests to the Proxy Set ID (see 'Configuring Proxy Sets Table' on
page 208) that is associated with the serving IP Group.
A Hunt Group or served IP Group can register to more than one serving IP Group (e.g.,
multiple ITSPs). This is done by configuring multiple entries in the Account table for the
same Hunt Group or served IP Group, but with different serving IP Groups, user
name/password, host name, and contact user values.
When using the Account table to register a Hunt Group, if all channels belonging to the
Hunt Group are down, the device un-registers the channels. If any channel belonging to the
Hunt Group is returned to service, the device registers them again. This ensures, for
example, that the Proxy does not send INVITEs to trunks that are out of service.
Notes:
•
For viewing Account registration status, see Viewing Endpoint Registration Status
on page 419.
•
The Account table can also be configured using the table ini file parameter,
Account.

To configure Accounts:
1. Open the Account Table page (Configuration tab > VoIP menu > SIP Definitions
submenu > Account Table).
2. In the 'Add' field, enter the desired table row index, and then click Add. A new row
appears.
Version 6.6 213
18. SIP Definitions
MP-11x & MP-124