Motorola DSP56303 User Manual page 200

SCI Programming Model
Table 8-2. SCI Control Register (SCR) Bit Definitions (Continued)
Bit Reset
Bit Name
Number Value
9 TE
8 RE
7 WOMS
8-14
0 Transmitter Enable
When TE is set, the transmitter is enabled. When TE is cleared, the transmitter
completes transmission of data in the SCI transmit data shift register, and then the
serial output is forced high (that is, idle). Data present in the SCI transmit data register
(STX) is not transmitted. STX can be written and TDRE cleared, but the data is not
transferred into the shift register. TE does not inhibit TDRE or transmit interrupts. Either
a hardware RESET signal or a software RESET instruction clears TE.
Setting TE causes the transmitter to send a preamble of 10 or 11 consecutive ones
(depending on WDS), giving you a convenient way to ensure that the line goes idle
before a new message starts. To force this separation of messages by the minimum
idle line time, we recommend the following sequence:
1. Write the last byte of the first message to STX.
2. Wait for TDRE to go high, indicating the last byte has been transferred to the
transmit shift register.
3. Clear TE and set TE to queue an idle line preamble to follow immediately the
transmission of the last character of the message (including the stop bit).
4. Write the first byte of the second message to STX.
In this sequence, if the first byte of the second message is not transferred to STX prior
to the finish of the preamble transmission, the transmit data line remains idle until STX
is finally written.
0 Receiver Enable
When RE is set, the receiver is enabled. When RE is cleared, the receiver is disabled,
and data transfer from the receive shift register to the receive data register (SRX) is
inhibited. If RE is cleared while a character is being received, the reception of the
character completes before the receiver is disabled. RE does not inhibit RDRF or
receive interrupts. Either a hardware RESET signal or a software RESET instruction
clears RE.
0 Wired-OR Mode Select
When WOMS is set, the SCI TXD driver is programmed to function as an open-drain
output and can be wired together with other TXD signals in an appropriate bus
configuration, such as a master-slave multidrop configuration. An external pullup
resistor is required on the bus. When WOMS is cleared, the TXD signal uses an active
internal pullup. Either a hardware RESET signal or a software RESET instruction
clears WOMS.
DSP56303 User's Manual
Description