User Management Configuration - H3C SecPath F1800-A Operation Manual

Operation Manual - Getting Started
H3C SecPath F1800-A Firewall
For the configuration of the PPP user, refer to the "AAA Configuration" in
Defence Operation"

2.5.2 User Management Configuration

User management configuration includes:
User authentication configuration
User priority configuration
User authentication is used to pass the valid user and deny the invalid user.
The command privilege level must be inferior or equal to the user priority. Both the
user priority and the command privilege level are divided into 4 levels from 0 to 3. The
user with different priority can use the command in different privilege level
accordingly.
User management configuration includes:
Configuring authentication mode
Configuring default user priority on the interface
Creating user and configuring priority
I. Configuring Authentication Mode
Using this command, you can configure the authentication mode when a user logs on
to the SecPath F1800-A from the user interface specified in the view.
none indicates no authentication is performed.
password indicates only the password is needed in the authentication without
need of the user name.
aaa refers to executing AAA authentication, and then you need to set the user
name and the password.
Do as follows in user interface view.
Table 2-46 Enabling or disabling terminal authentication
Enable terminal authentication.
Disable terminal authentication.
By default, the user interface of VTY applies the password authentication while user
interfaces of other types do not perform the terminal authentication.
Usually, the keyword aaa is selected to perform AAA local authentication when
configuring a Telnet or HyperTerminal user.
1) Local password authentication
Do as follows in user interface view.
of this manual.
Action
1-49
Chapter 2 Basic SecPath F1800-A Configuration
Command
authentication-mode { aaa | password }
authentication-mode none
"06-Security