Ftp Configuration; Introduction To Ftp - H3C SecPath F1800-A Operation Manual

Operation Manual - System Management
H3C SecPath F1800-A Firewall
Table 2-4 Configuring prompt mode of file system
Configure prompt mode of file system.
2.1.6 Configuration Example
# Display files in the current directory. "fl" is a sub-directory of the directory "flash:/".
<SecPath> dir
Directory of flash:/
0 -rw-
1 -rw-
2 drw-
31750 KB total (23284 KB free)
# Copy the file from "flash: /fl/sample.txt" to "flash:/sample.txt".
<SecPath> copy flash./fl/sample.txt flash:/sample.txt
Copy flash/fl/sample.txt to flash:/sample.txt ?[Y/N]:y
% Coped file flash./fl/sample.txt flash:/sample.txt
# Display files in the current directory. Then you can find the file has been copied to
the specified directory.
<SecPath> dir
Directory of flash:/
0 -rw-
1 -rw-
2 drw-
3 -rw-
31750 KB total (23284 KB free)

2.2 FTP Configuration

2.2.1 Introduction to FTP

FTP is an application layer protocol in TCP/IP protocol suite. It mainly provides users
with file transmission between remote hosts. FTP is implemented on the basis of file
system.
FTP services provided by the firewall system are shown in
Action
8475452 May 12 2005 11:29:38
94696 May 12 2005 11:35:31
- May 12 2005 11:37:20
8475452 May 12 2005 11:29:38
94696 May 12 2005 11:35:31
- May 12 2005 11:37:20
94696 May 12 2005 11:35:31
2-28
Chapter 2 File Management
Command
file prompt { alert | quiet }
SP1800-VRP3.30-0313(08).bin
matnlog.dat
fl
SP1800-VRP3.30-0313(08).bin
matnlog.dat
fl
sample.txt
Table 2-5.