Establishment Through Ssh - H3C SecPath F1800-A Operation Manual

Operation Manual - Getting Started
H3C SecPath F1800-A Firewall
<SecPath>
Note:
The host name can be either the SecPath F1800-A host name or the SecPath
F1800-A IP address.
Step 4: Enter commands to configure the SecPath F1800-A or view its running state.
If you need to use the on-line help, you can enter "?" at any time. To use specific
commands, refer to the following chapters.
Note:
During the configuration of the SecPath F1800-A through Telnet, do not change the IP
address connected on the SecPath F1800-A through Telnet; otherwise, Telnet will be
disconnected. To change the IP address, you can change it through the console
interface or the AUX interface. Then, you can establish a connection with the new IP
address through Telnet.

2.2.3 Establishment Through SSH

When a user telnets the SecPath F1800-A in an insecure network, SSH can provide
secure information guarantee and powerful authentication to protect the SecPath
F1800-A from attacks, such as IP spoofing and plain text password capture.
Establishment of configuration environment through SSH is similar to that through
Telnet.
Step 1: To establish local configuration environment, you only need to connect the
Ethernet interface on your computer with that on the SecPath F1800-A through LAN,
or to implement network interworking through hub or Ethernet switch; To establish
remote configuration environment, you need to connect your computer with the
SecPath F1800-A through WAN.
Step 2: Run the Telnet program on your computer and set its "Term Type" to VT100,
and then enter the IP address of the Ethernet interface on the SecPath F1800-A (or
enter the IP address of the WAN interface on the remote computer) to connect with
the SecPath F1800-A.
Step 3: Set SSH parameters on the SecPath F1800-A. For more details, see the 2.7.4
"Configuring SSH Terminal
Chapter 2 Basic SecPath F1800-A Configuration
Service" in this chapter.
1-24