Adding A User To An Snmp Group; Configuring Syscontact - H3C SecPath F1800-A Operation Manual

Operation Manual - System Management
H3C SecPath F1800-A Firewall
Table 4-5 Configuring an SNMP group
Configure an SNMP group.
Delete an SNMP group.

4.2.5 Adding a User to an SNMP Group

Do as follows in system view.
Table 4-6 Adding a user to an SNMP group
Add a user to an SNMP group.
Delete a user from an SNMP
group.

4.2.6 Configuring sysContact

System contact (sysContact) is a MIB variable in MIB II system group. It records ID
and contact method of administrators. Thus, you can set the parameter to save key
information to the firewall for the sake of query in future.
Do as follows in system view.
Action
Action
2-58
Chapter 4 SNMP Configuration
Command
snmp-agent group { v1 | v2c } group-name
[ read-view read-view ] [
write-view ] [ notify-view notify-view ] [ acl
acl-number ]
snmp-agent group
[ authentication | privacy ] [ read-view
read-view ] [ write-view
[ notify-view notify-view ] [ acl acl-number ]
undo snmp-agent group { v1 | v2c }
group-name
undo snmp-agent group v3 group-name
[ authentication | privacy ]
Command
snmp-agent usm-user { v1 | v2c } user-name
group-name [ acl acl-number ]
snmp-agent usm-user
group-name [ [ authentication-mode { md5 |
sha } auth-password ] [ privacy-mode des56
priv-password ] ] [ acl acl-number ]
undo snmp-agent usm-user { v1 | v2c }
user-name group-name
undo snmp-agent usm-user v3 user-name
group-name [ engineid engine-id | local ]
write-view
v3 group-name
write-view ]
v3 user-name