Creating A Radius Server Template; Configuring A Radius Authentication Server - H3C SecPath F1800-A Operation Manual

Operation Manual - Security Defence
H3C SecPath F1800-A Firewall

5.3.1 Creating a RADIUS Server Template

The RADIUS server template refers to a group of RADIUS servers. To configure
servers in the RADIUS server template, you must create a RADIUS server template
first.
Do as follows in system view.
Table 5-13 Creating a RADIUS server template
Create a RADIUS server template and
enter RADIUS view.
Delete a RADIUS server template.
If the RADIUS server template specified does not exist, you can create a RADIUS
server template with the name specified and enter RADIUS view.
In the RADIUS view, you can configure the RADIUS server template.
The system supports 128 RADIUS server templates at most. The configuration can
be modified only when the template is not in use.
If the template is in use while being deleted, the system will output the failure prompt
information.

5.3.2 Configuring a RADIUS Authentication Server

Do as follows in RADIUS view.
Table 5-14 Configuring a RADIUS authentication server
Configure
authentication server.
Configure
authentication server.
Remove a RADIUS authentication
server.
The IP addresses assigned to the primary authentication server and the secondary
authentication server cannot be identical. Otherwise, the configuration will fail.
Action
Action
a primary RADIUS
a secondary RADIUS
6-99
Command
radius-server template template-name
undo radius-server
template-name
Command
radius-server authentication ip-address
port
radius-server authentication ip-address
port secondary
undo radius-server
[ secondary ]
Chapter 5 AAA
template
authentication