Typical Example For Configuring Ntp; Configuring The Ntp Server - H3C SecPath F1800-A Operation Manual

Operation Manual - System Management
H3C SecPath F1800-A Firewall
Debug NTP.

3.4 Typical Example for Configuring NTP

3.4.1 Configuring the NTP Server

I. Networking Requirements
Configure SecPath 1 clock as NTP master clock, and its stratum to 2. Configure
SecPath 1 as time server of SecPath 2, SecPath 1 works in server mode, and
SecPath 2 works in client mode.
II. Networking Diagram
SecPath1
SecPath2
Figure 3-2 Typical NTP networking
III. Configuration Procedure
1) Configuring SecPath 1
# Configure the local clock as NTP master clock, and its stratum to 2.
<SecPath1> system-view
[SecPath1] ntp-service refclock-master 2
2) Configuring SecPath2
# Configure SecPath 1 as time server.
<SecPath2> system-view
[SecPath2] ntp-service unicast-server 1.0.1.11
After the above configuration, SecPath 2 is synchronized to SecPath 1. Before the
synchronization, the status of SecPath 2 is shown below:
Action
Ethernet0:
1.0.1.11
1.0.1.2
Quidw ay0
Ethernet0:
1.0.1.12
2-46
debugging ntp-service { access |
adjustment | authentication | event |
filter | packet | parameter | refclock |
selection | synchronization | validity |
all }
Ethernet0:
3.0.1.31
SecPath3
3.0.1.2
Ethernet0:
3.0.1.32
SecPath4
Ethernet0:
3.0.1.33
SecPath5
Chapter 3 NTP Configuration
Command