Configuring Ospf Peer Authentication - H3C SecPath F1800-A Operation Manual

Operation Manual - Network and Routing Protocol
H3C SecPath F1800-A Firewall
[Router B-Ethernet2/0/0] ip address 192.1.1.2 255.255.255.0
[Router B-Ethernet2/0/0] interface ethernet 1/0/0
[Router B-Ethernet1/0/0] ip address 193.1.1.2 255.255.255.0
[Router B-Ethernet1/0/0] quit
[Router B] router id 2.2.2.2
[Router B] ospf
[Router B-ospf] area 0
[Router B-ospf-area-0.0.0.0] network 192.1.1.0 0.0.0.255
[Router B-ospf-area-0.0.0.0] quit
[Router B-ospf] area 1
[Router B-ospf-area-0.0.0.1] network 193.1.1.0 0.0.0.255
[Router B-ospf-area-0.0.0.1] vlink-peer 3.3.3.3
# Configure Router C.
[Router C] interface ethernet 2/0/0
[Router C-Ethernet2/0/0] ip address 152.1.1.1 255.255.255.0
[Router C-Ethernet2/0/0] interface ethernet 1/0/0
[Router C-Ethernet1/0/0] ip address 193.1.1.1 255.255.255.0
[Router C-Ethernet1/0/0] quit
[Router C] router id 3.3.3.3
[Router C] ospf
[Router C-ospf] area 1
[Router C-ospf-area-0.0.0.1] network 193.1.1.0 0.0.0.255
[Router C-ospf-area-0.0.0.1] vlink-peer 2.2.2.2
[Router C-ospf-area-0.0.0.1] quit
[Router C-ospf] area 2
[Router C –ospf-area-0.0.0.2] network 152.1.1.0 0.0.0.255

5.4.4 Configuring OSPF Peer Authentication

I. Networking Requirement
In Figure
update information with Router B; while it adopts MD5 encryption authentication when
it exchanges route update with Router C.
The Ethernet interfaces of Router A and Router B are in the OSPF Area 0. The
Ethernet interfaces of Router A and Router C are in Area 1 and MD5 authentication is
configured on them.
5-7, Router A adopts pure text authentication when it exchanges route
5-77
Chapter 5 OSPF Configuration