Displaying And Debugging Ppp; Typical Example For Configuring Ppp; Pap Authentication Example - H3C SecPath F1800-A Operation Manual

Operation Manual - Link Layer Protocol
H3C SecPath F1800-A Firewall

2.3 Displaying and Debugging PPP

You can use the display command in any view to view the running state and thus
verify the effect of PPP.
Table 2-16 Displaying and debugging PPP
View PPP configuration and state.
View PPP compression statistics of IP
packet headings.

2.4 Typical Example for Configuring PPP

2.4.1 PAP Authentication Example

I. Networking Requirement
As shown in
through the Serial 3/0/0, and the SecPath F1800-A is required to authenticate the
router in PAP mode.
II. Networking Diagram
SecPath
Figure 2-2 Networking diagram of PAP and CHAP authentication
III. Configuration Procedure
1) Configuring the SecPath F1800-A
[SecPath-aaa] local-user H3C2 password simple SecPath
[SecPath-aaa]quit
[SecPath] interface serial 3/0/0
[SecPath-Serial3/0/0] ppp authentication-mode pap
2) Configuring the router
[SecPath] interface serial 3/0/0
[SecPath-Serial3/0/0] ppp pap local-user SecPath2 password simple SecPath
Action
Figure 2-2, the SecPath F1800-A and the router are interconnected
Serial3/0/0
Serial3/0/0
display interface
interface-number
display ppp compression iphc { rtp |
tcp } [ interface-type interface-number ]
Router
4-19
Chapter 2 PPP Configuration
Command
interface-type