H3C SecPath F1800-A Operation Manual page 109

Operation Manual - System Management
H3C SecPath F1800-A Firewall
Configure channel through which
information is output to log host and
other parameters.
Disable information output to log
hosts.
Configure trap buffer size and
channel through which information
is output to trap buffer.
Disable trap buffer or restore its
default value.
At present, the system assigns a default channel for each output destination, as
shown in
Table 1-22 Default channels for information output
Output destination
Console
Monitoring terminal
Log host
Trap buffer
Log buffer
Snmp
Note:
The configuration for each output destination is independent of each other. To enable
the configuration to take effect, you must enable information center first.
VI. Configuring the Source Address to Send Log Information
Do as follows in system view.
Action
Table 1-22.
Chapter 1 System Maintenance Management
info-center loghost X.X.X.X [ channel
{ channel-number | channel-name } | facility
local-number | language { chinese |
english } ] *
undo info-center loghost X.X.X.X
info-center
{ channel-number | channel-name } | size
buffersize ] *
undo info-center trapbuffer [ channel |
size ]
Channel number
0
1
2
3
4
5
2-16
Command
trapbuffer [ channel
Default channel name
Console
Monitor
Loghost
trapbuffer
Logbuffer
snmpagent