Configuring The Channel Interface Of Backup Session Table; Displaying And Debugging Dual-System Hot Backup - H3C SecPath F1800-A Operation Manual

Operation Manual - Reliability
H3C SecPath F1800-A Firewall
Disable manual batch backup.
Note:
Manual batch backup is independent of automatic real-time backup. In this backup
manner the undo and reset commands cannot be backed up.

2.2.4 Configuring the Channel Interface of Backup Session Table

To apply the HRP on the SecPath F1800-A firewall, you need to configure one or more
high-speed interfaces of the backup session table. You can configure up to 24 such
interfaces on one device. Besides, you also need to configure VRRP on the interfaces
and add the interfaces to the VGMP group.
Do as follows in system view.
Table 2-4 Configuring an interface of backup session table
Configure an interface of backup session
table.
Remove an interface of backup session
table.

2.3 Displaying and Debugging Dual-system Hot Backup

You can use the display command in any view to view the running state and verify the
configuration of HRP dual-system hot backup.
You can use the debugging command in user view to debug HRP dual-system hot
backup.
Table 2-5 Displaying and debugging HRP
View HRP.
Debug HRP.
Action
Action
Action
8-47
Chapter 2 Dual-System Hot Backup
Command
undo hrp sync
connection-status ]
Command
hrp interface
interface-number
undo hrp interface interface-type
interface-number
Command
display hrp [ verbose ]
debugging hrp { all | state | packet |
timer }
[ config |
interface-type