Connecting Multiple Lans With The Secpath F1800-A In Transparent Mode - H3C SecPath F1800-A Operation Manual

H3c secpath f1800-a firewall

Hide thumbs Also See for H3C SecPath F1800-A:

Table of Contents

Operation Manual - Getting Started

H3C SecPath F1800-A Firewall

3.6.2 Connecting Multiple LANs with the SecPath F1800-A in Transparent

I. Networking Requirements

In a mansion, there are several PCs and servers in LAN1 on one floor, and several

PCs and servers in LAN2 on another floor. You are required to connect LAN 1 with

LAN 2 through the SecPath F1800-A.

II. Networking Diagram

Figure 3-11 Networking in transparent mode

III. Configuration Procedure

# Configure the SecPath F1800-A to work in transparent mode.

[SecPath] firewall mode transparent

# Set aging time of the firewall forwarding table to 300 seconds.

[SecPath] firewall transparent-mode mac-aging-time 300

# Set the default filter rule of the firewall.

[SecPath] firewall packet-filter default permit interzone trust untrust

Chapter 3 Working Mode

Chapters

Table of Contents

Do you have a question about the H3C SecPath F1800-A and is the answer not in the manual?