H3C SecPath F1800-A Operation Manual page 306

Operation Manual - Network and Routing Protocol
H3C SecPath F1800-A Firewall
Do as follows in BGP view, multicast sub-address family view, VPNv4 sub-address
family view or L2VPN address family view.
Table 6-7 Configuring peer state
Action
Enable a peer.
Disable a peer.
To exchange routing information between BGP speakers, first enable the peer group
in unicast address family, and then add the peers in unicast address family to the
enabled peer group.
V. Configuring Description for a Peer or Peer Group
For the ease of network maintenance, you can configure description for the BGP peer
or peer group.
The descriptions configured for the peer and peer group are mutually independent
and unaffected.
Do as follows in BGP view or VPN instance view.
Table 6-8 Configuring description for a peer or peer group
Configure description for a peer.
Configure description for a peer
group.
Remove the description for a
peer.
Remove the description for a
peer group.
VI. Configuring Timer of a Specified Peer or Peer Group
The peer timer command is used to configure the timer of a specified BGP peer or
peer group. The preference of this command is higher than the timer command that is
used to configure timers for all BGP peers.
Do as follows in BGP view or VPN instance view.
peer { group-name | peer-address } enable
undo peer { group-name | peer-address } enable
Action
5-89
Chapter 6 BGP/MBGP Configuration
Command
Command
peer peer-address description description-line
peer group-name description description-line
undo peer peer-address description
undo peer group-name description