Typical Example For Configuring Vlan - H3C SecPath F1800-A Operation Manual

Operation Manual - Link Layer Protocol
H3C SecPath F1800-A Firewall
Table 1-8 Displaying and debugging VLAN
View the status of a VLAN and
the ports it contains.
View the untagged ports of all or
a specified VLAN.
View the tagged port of all or a
specified VLAN.
Debug VLAN packets.
Disable VLAN packet debugging.
Note:
If you do not specify any optional parameter for the debugging vlan packet
command, you will debug all the packets of all the VLAN sub-interfaces.

1.4 Typical Example for Configuring VLAN

I. Networking Requirements
The following is a configuration example of layer 3 forwarding mode (sub-interface).
As shown in
Thus, the workstations A, B, C and D connected to these Switches belong to VLAN 10
or VLAN 20.
It is required:
The addresses of the SecPath F1800-A sub-interfaces Ethernet 3/0/0.1,
Ethernet 3/0/0.2, Ethernet 4/0/0.1, and Ethernet 4/0/0.2 are 1.0.0.1, 2.0.0.1,
3.0.0.1, and 4.0.0.1 respectively.
Communication can be carried out between workstation A and B as well as
between C and D. Namely, through the same switch, workstations in different
VLANs can communicate with each other.
Communication can be carried out between workstation A and C, as well as
between B and D. Namely, through different switches, workstations in the same
VLAN can communicate with each other.
Communications can be carried out between workstations A and D, and between
B and C. Namely, different switches and different VLANs can communicate with
each other.
Action
Figure 1-2, Switch 1 and Switch 2 specify the VLAN attributes of ports.
Command
display vlan vlan-id
display vlan port-default [ vid vlan-id ]
display vlan port-trunk [ vid vlan-id ]
debugging vlan
interface-type interface-number ] [ vid vlan-id ]
undo debugging vlan packet [ interface
interface-name ] [ vid vlan-id ]
4-7
Chapter 1 VLAN Configuration
packet [ interface