Operation Manual - Getting Started
H3C SecPath F1800-A Firewall
Table 3-5 Setting aging time of MAC address forwarding table
Set aging time of MAC address
forwarding table.
Restore its default value.
3.4 Composite Mode Configuration
Composite mode configuration involves:
Configuring the SecPath F1800-A to work in composite mode
Setting other parameters in composite mode
3.4.1 Configuring the SecPath F1800-A to Work in Composite Mode
Do as follows in system view.
Table 3-6 Configuring the SecPath F1800-A to work in composite mode
Configure the SecPath F1800-A to work in
composite mode.
3.4.2 Setting Other Parameters in Composite Mode
When working in composite mode, the SecPath F1800-A is mainly used for
dual-system hot standby in transparent mode. When two firewalls for dual-system hot
backup work in composite mode, the interfaces with IP addresses should be
configured with VRRP.
For details, refer to the "Dual-System Hot Backup" chapter in
Operation"
For the configuration of other interfaces, refer to the configuration in transparent
mode.
3.5 Displaying and Debugging Firewall Working Mode
You can use the display command in any view to view the running state and verify the
configuration of working mode.
Action
Action
module of this manual.
firewall
mac-aging-time seconds
undo
firewall
mac-aging-time
firewall mode composite
1-81
Chapter 3 Working Mode
Command
transparent-mode
transparent-mode
Command
"08-Reliability