Enabling Or Disabling Snmp Version; Configuring A Community Name; Configuring An Snmp Group - H3C SecPath F1800-A Operation Manual

Operation Manual - System Management
H3C SecPath F1800-A Firewall
By default, SNMP Agent service is disabled.

4.2.2 Enabling or Disabling SNMP Version

Do as follows in system view.
Table 4-3 Enabling or disabling SNMP version
Enable SNMP version.
Disable SNMP version.

4.2.3 Configuring a Community Name

SNMP v1 and SNMP v2c adopts community name authentication. Such SNMP
packets that do not match the community name authorized by the device will be
discarded. The SNMP community is named by a character string called community
name. Different communities can have read-only or read-write access mode. The
community with a read-only authority can only query device information, while that
with a read-write authority can configure the device.
Do as follows in system view.
Table 4-4 Configuring a community name
Configure a community name and access
authority.
Cancel the community name.

4.2.4 Configuring an SNMP Group

Do as follows in system view.
Action
Action
2-57
Chapter 4 SNMP Configuration
Command
snmp-agent sys-info version { { v1 |
v2c | v3 } * | all }
undo snmp-agent sys-info version
{ { v1 | v2c | v3 } * | all }
Command
snmp-agent community { read |
write } community-name [ [ mib-view
view-name ] | [ acl acl-number ] ]*
undo snmp-agent
community-name
community