Displaying System Status Information - H3C SecPath F1800-A Operation Manual

Operation Manual - Getting Started
H3C SecPath F1800-A Firewall
Note:
Each command has a default view and a privilege level. You do not need to
reconfigure them.

2.4.6 Displaying System Status Information

The display command is used to collect system status information, which can be
classified as:
Viewing system configuration information
Viewing system running status
Viewing system statistics
For the display command of various protocols and interfaces, refer to the related
sections. This section only introduces the display command associated with the
system.
Do as follows in any view.
Table 2-44 Displaying system status
View system version.
View system clock.
View all users.
View
information.
View
information.
View debugging status.
View
information.
During system fault or routine maintenance, it is needed to collect a great deal of
information to help troubleshooting. However, there are so many display commands
that it is hard to collect all the information at a time. You can use the display
diagnostic-information command to collect the running information of the current
modules in the system.
Action
saved configuration
current configuration
technical support
Chapter 2 Basic SecPath F1800-A Configuration
Command
display version
display clock
display users [ all ]
display saved-configuration
display current-configuration
display debugging [ interface { interface-type
interface-number } ] [ module-name ]
display diagnostic-information
1-46