H3C SecPath F1800-A Operation Manual page 30

Operation Manual - Getting Started
H3C SecPath F1800-A Firewall
PC running Telnet client programs
Figure 2-12 Establishing remote configuration environment through WAN
Step 2: Run the Telnet program on your computer, and then enter the IP address of
the Ethernet interface on the SecPath F1800-A (or enter the IP address of the WAN
interface on the remote computer) to connect with the SecPath F1800-A. If the prompt
"Too many users!" appears, you need to reconnect later. The interface is shown in
Figure 2-13.
Figure 2-13 Running the Telnet program
Step 3: The Telnet interface displays the following information. Enter the user name
"telnetuser" and the password "telnetpwd", and the command line prompt (such as
<SecPath>) appears.
*********************************************************
*
* Without the owner's prior written consent,
*no decompiling or reverse-engineering shall be allowed.*
*********************************************************
Login authentication
Username:telnetuser
Password:*********
Note:The max number of VTY users is 5,and the current number of VTY users on
line is 1.
Local Ethernet
PC
Router
Server
All rights reserved (1997-2004)
Chapter 2 Basic SecPath F1800-A Configuration
Remote Ethernet
WAN
SecPath
WAN port
1-23
Server
*
*