Mac And Ip Address Binding Configuration - H3C SecPath F1800-A Operation Manual

Operation Manual - Security Defence
H3C SecPath F1800-A Firewall
undo firewall mac-binding enable
By default, the address binding is disabled.

2.7.2 MAC and IP Address Binding Configuration

MAC and IP address binding configuration includes:
Configuring MAC and IP address binding map
Enabling or disabling MAC and IP address binding
I. Configuring MAC and IP Address Binding Map
Do as follows in system view.
Table 2-52 Configuring MAC and IP address binding
Configure MAC and IP address
binding map.
Remove MAC and IP address binding
map.
Caution:
Address binding is regarded as another kind of expression of static ARP.
When the address binding is enabled, if the IP address in the address binding exists in
the static ARP list, the entries in the static ARP table will be deleted. If the same IP
address has been configured in the address binding, static ARP configuration will fail
and receive prompt.
However, when the address binding is disabled, the same IP address can be
configured in both address binding and static ARP.
II. Enabling or Disabling MAC and IP Address Binding
Do as follows in system view.
Table 2-53 Enabling or disabling MAC and IP address binding
Enable MAC and IP address binding.
Disable MAC and IP address binding.
Action
Action
6-61
Chapter 2 Security Policy
Command
firewall mac-binding
mac-address
undo firewall
{ source-address | all }
Command
firewall mac-binding enable
undo firewall mac-binding enable
source-address
mac-binding