Specifying Attributes Of Ike Peer - H3C SecPath F1800-A Operation Manual

Operation Manual - VPN
H3C SecPath F1800-A Firewall
Table 3-19 Setting local ID used in IKE negotiation
Set local ID used in IKE exchange.
Delete the local ID.

3.2.7 Specifying Attributes of IKE Peer

I. Creating IKE Peer and Entering IKE Peer View
A series of attribute data can be defined through IKE peer to describe parameters
required in IKE negotiation, including:
Configuring IKE negotiation mode
Configuring IKE proposal
Setting ID for IKE peer
Configuring NAT traversal
Configuring shared key
Assigning the remote IP address
Configuring the remote name
Do as follows in system view.
Table 3-20 Creating IKE peer and entering IKE peer view
Create IKE peer and enter IKE peer view.
Delete the specified IKE peer.
II. Configuring IKE Negotiation Mode
Do as follows in IKE peer view.
Table 3-21 Configuring IKE negotiation mode
Perform IKE negotiation mode.
Restore the default IKE negotiation
mode.
III. Configuring IKE Proposal
Do as follows in IKE peer view.
Action
Action
Action
7-59
Chapter 3 IPSec Configuration
Command
ike local-name router-name
undo ike local-name
Command
ike peer peer-name
undo ike peer peer-name
Command
exchange-mode { main | aggressive }
undo exchange-mode