Shutting Down An Interface; Setting Advanced Parameters For Interfaces - H3C SecPath F1800-A Operation Manual

Operation Manual - Interface
H3C SecPath F1800-A Firewall

1.2.5 Shutting down an Interface

Do as follows in interface view.
Table 1-5 Shutting down an interface
Shutdown an interface.
Restart the interface.
Note:
Shutting down an interface will make this interface stop working. So use the
shutdown command cautiously.
When the physical or the protocol status changes, the system will automatically
output the prompt. It is shown in
Table 1-6 Interface status information
Interface status information
%Interface interface-name changed
state to DOWN
%Interface interface-name changed
state to UP
%Line protocol protocol-name on
interface interface-name, changed
state to DOWN
%Line protocol protocol-name on
interface interface-name, changed
state to UP

1.2.6 Setting Advanced Parameters for Interfaces

Before configuring the interface, you need to know:
Networking requirement
Networking diagram
In addition, you should make sure:
The connection of the physical interface, the physical interface working mode to
be selected and the relevant working parameters.
Action
Table 1-6.
3-3
Chapter 1 Interface Configuration Overview
Command
shutdown
undo shutdown
Definition
The physical status of the interface
changed to Down.
The physical status of the interface
changed to Up.
The protocol status of the interface
changed to Down.
The protocol status of the interface
changed to Up.