Setting Parameters For A Car Level; Assigning An Ip Address To A Ppp User - H3C SecPath F1800-A Operation Manual

Operation Manual - Security Defence
H3C SecPath F1800-A Firewall
Disable the recording about the
connection information.
Record the system-level events.
Disable the recording about the
system-level events.

5.2.5 Setting Parameters for a CAR Level

To manage the bandwidth of access users, you must configure a CAR level. Moreover,
you must apply the level to some or some type of user accounts.
Do as follows in AAA view.
Table 5-10 Setting parameters for a CAR level
Set parameters for a CAR level.
Remove the configuration.
The CAR level configuration is divided into an input configuration and an output
configuration.

5.2.6 Assigning an IP Address to a PPP User

If a user accesses the BAS over PPP, he can obtain an IP address through the PPP
address negotiation.
There are two methods to assign an IP address to a PPP user.
Configuring an IP address pool and then specifying it to some interface in
interface view
Assigning the IP address of an interface directly to the peer instead of
configuring an address pool
I. Configuring an IP Address Pool
When a PPP user logs in, he needs to obtain an IP address from the BAS.
Configure a local address pool in AAA view (as the system address pool) or within a
domain.
Action
Action
6-96
Command
undo outbound recording-scheme
system recording-scheme scheme-name
undo system recording-scheme
Command
user-car level-number
burst-size excess-burst-size output target-rate
burst-size excess-burst-size
undo user-car level-number
Chapter 5 AAA
input target-rate