Typical Example For Configuring The Null Interface - H3C SecPath F1800-A Operation Manual

H3c secpath f1800-a firewall

Hide thumbs Also See for H3C SecPath F1800-A:

Table of Contents

Operation Manual - Interface

H3C SecPath F1800-A Firewall

The Maximum Transmit Unit is 1500

Internet protocol processing is disable

4.4.4 Typical Example for Configuring the Null Interface

Since any packet reaching the null interface will be dropped, you can directly send

those packets to be filtered to the Null0 interface, rather than configure ACL.

For example: Use the following static routing configuration command:

[SecPath] ip route-static 192.101.0.0 255.255.0.0 null 0

All the packets sent to network segment 192.101.0.0 will be dropped.

Chapter 4 Virtual Interface Configuration

Table of Contents

Do you have a question about the H3C SecPath F1800-A and is the answer not in the manual?